HomeMy WebLinkAboutErosion Control Violation DEPARTMENT OF PUBLIC WORKS
215 Church Avenue
P.O.Box 1130
11111*)
Oshkosh,Wisconsin 54903-1130
Ph.(920)236-5065 OJHKOJH
Fax(920)236-5068 ON THE WATER
August 3,2012
Mr.Nate Keller
J.H.Findorff&Son,Inc.
1600 N 6th St
Milwaukee,WI 53212
RE: Erosion Control Violation—Paine Art Center Carriage House Addition(1410 Algoma Blvd.)
Dear Mr.Keller:
A recent field visit to the subject site has revealed some deficiencies with the erosion control measures installed onsite.
The sediment logs(which are acting as your perimeter control BMP's)are not fully installed along the site adjacent to
the city right-of-way. These sediment logs need to be overlapping to form a continuous barrier to site runoff. Please
repair your sediment logs to form a continuous barrier around your site per the manufactures recommended installation
technique. Also,your inlet protection adjacent to your project area in the city right-of-way needs attention. Please
refer to the inspection report and map for corrective measures and locations of the defective inlet protection. Your inlet
protection needs to comply with DNR technical standard 1060(Storm Drain Inlet Protection for Construction Sites).
This construction site is governed by the rules and regulations of the State of Wisconsin,Department of Safety&
Professional Services along with the City of Oshkosh municipal code. In particular, Section SPS 360.20 of the State
Administrative Code and Chapter 14 of the City of Oshkosh Municipal Code. As an Agent Municipality,the City of
Oshkosh is authorized to enforce SPS 360.20 of the State Administrative Code along with enforcement of Chapter 14
of the City of Oshkosh Municipal Code. We prefer to work with you to bring the site into compliance with the Erosion
Control Plan, and not to have to issue citations. Therefore,we are asking you make the above corrections by August
8th,2012.
If you have any questions,please do not hesitate to contact us.
Sincerely,
Kris Lyons,CPESC.
CET
Encl.:Construction Site Inspection Report
cc: James Rabe,P.E.,Civil Engineering Supervisor(w/o Encl.)
Laura Gray,Civil Engineer(w/o Encl.)
John Zarate, Chief Building Official(w/o Encl.)
File
I:\Engineering\SWMP-Non-Residential\1410 Algoma Blvd-Paine Art
Page 1 of 1
Center\EC Inspections\20120731\Erosion Control Violation Letter.doc
�EpAHTdtF,,41
.<j Safety and Buildings Division 1113310 Rev
Buildings, HVAC Compliance Statement
This form is required to be submitted by the supervising professional (architect, engineer, HVAC designer or electrical
designer) observing construction of projects within buildings with total volume of 50,000 cubic feet or greater and
bleachers (Comm 61.40). Failure to submit this form may result in penalties as specified in Comm 61.23 and/or local
ordinances. This form must be submitted prior to the plan approval expiration date or another submittal may be required.
Personal information you provide may be used for secondary purposes[Privacy Law, s. 15.04(1)(m)].
General Instructions: Prior to the initial occupancy of new buildings or additions and the final occupancy of
altered existing buildings, submit this completed and signed form to the municipal building inspection
office (refer to the plan approval letter for agency address) and Safety and Buildings Division, 10541N
Ranch Road Hayward, WI. 54843. Note: If the review was done by the municipality, the compliance
statement goes only to the municipal building inspector. A copy is not needed by S&B.
1. Project Information: Please fill in the following with information from the plan approval letter.
Transaction ID Number 2096106 Project Name Schwab Retail Development—Phase 1 Revision inc. Int. Build-out
Site Number 779542
Site location (number&street) 1821 Jackson Street
X City Village ❑ Town Oshkosh County of Winnebago
2. Purpose of This Statement: (Check Box A, B, C, or D to indicate purpose and complete any other applicable
boxes and information. Attach additional pages if necessary.)
Check those which apply: X Building Object ID#1372580 ❑ HVAC Object ID#
❑ Lighting Object ID#
❑ Partial Completion
Description of Portion Completed
A) ,' Statement of Substantial Compliance
To the best of my knowledge and belief, based on onsite observation,construction of the following building and/or
HVAC items for this project have been completed in substantial compliance with the approved plans and specifications.
)(Building/Lighting Items
1. Structural system including submittal and erection of all building components 10. Exterior lighting&control requirements
(trusses,precast,metal building,etc.) 11. Interior lighting&control requirements
2. Fire protection systems(sprinklers,alarms,smoke detectors)designed, 12. All conditions of lighting plan approval
installed,and tested(including forward flow on back flow devices)by and applicable variances
appropriately registered professionals
3. Shaft and stairway enclosure
4. Exits including exit and directional lights
5. Fire-resistive construction,enclosure of hazards,fire walls,labeled doors,class ❑ HVAC Items
of construction,fire stopped penetrations
6. Sanitation system(toilets,sinks,drinking facilities) 1. HVAC system including final test
7. Barrier-free including Comm 18 elevators and lifts 2. All conditions of HVAC plan approval and
8. Energy envelope requirements applicable variances
9. All conditions of building plan approval and applicable variances
The following items are not in compliance and must be addressed:
B) ❑ Statement of Noncompliance
Due to the following listed violations,this project is not ready for occupancy:
C) ❑ Supervising Professional Withdrawn From Project (Use A or B above to indicate project status as of this date.)
0) ❑ Project Abandoned
3. Supervising Professional Signature for:
X Building ❑ HVAC ❑ Lighting Adam Heindel,AIA,LEED AP ate •to • y Z
Name(please print or type)
Phone number 920-926-9800 Customer ID#1046066 Signature
SRT)-977n IR 1 1/111