HomeMy WebLinkAboutBuilding P5-112-790R OJHKO.IH City of Oshkosh
ON THE WATER
July 10, 1990
Ron Leichtfuss
110 Cimarron Place
Oshkosh, WI 54901
Dear Mr. Leichtfuss:
RE: Garage s
/3o ez.77 -,:v4,� o7-- /i
File #P4112 -79OR
Building plans have been reviewed by this office for compliance
with important code requirements. The drawings are stamped
"Construction may proceed." All items that are required to be
changed by this letter must be corrected before commencing that
part of the work. This approval is not a Building Permit.
Necessary city permits must be secured before commencing work.
You are hereby advised that the owner, as defined in Chapter
101.01(i) of the Wisconsin State Statutes, is responsible for all
code requirements not specifically cited herein. Code
requirements are set forth in Chapters 50 through 64 of the rules
of the Department of Industry, Labor and Human Relations.
The building will be inspected during construction and a final
inspection will be made after completion to insure complete
compliance with city and state codes.
The architect, professional engineer, builder or owner shall keep
at the building, as evidence of approval, one set of plans bearing
the stamp of approval.
ILHR 50.12 Roof truss plans must be submitted to this office and
be approved prior to installation. An examination fee will be
required. Plans must be submitted with a completed SB- 118form
from the building designer.
ILHR 51.22, 59.23(4)(2) Fire extinguishers must be provided per
this section.
Sincerely,
JOHN L. SULLIVAN
Building Inspector
JLS :mr
Safety Buildings Division PLANS APPROVAL APPLICATION
..01 E. Wasnington Avenue E
P.O. Sox 7969 DEPARTMENT OF INDUSTRY, LABOR ANO HUMAN RELATIONS 4, /fZ 7 y0 Z.
Madison. WI 53707 BUREAU OF BUILDINGS AND STRUCTURES PLAN NO P 5/ i 3 7 90 2
INSTRUCTIONS: Fill in all applicable data. Submittal of this Plan Approval Application form is required with each plan submittal. with a minimum of 4
sets of plans. Data required is described in code section ILHR 50.12.
SUBMIT PLUMBING PLANS SEPARATELY. ACCOMPANIED BY PLUMBING PLAN APPLICATION FORM S80 -6154.
Name of Own r Building Occupancy or Use Designer or Design firm BLDG HVAC
Q r /__3C? r/ JV�01`I.ltiviQ'G
Company Name I Tenant Nam ®(if any) Street No.
Street No. Building is located at: City State Zip
in the City Town Village
C.ty State Zip of Contact Person
County of:
Previous Owner it any Return Plans to: 0 Owner Designer Phone
Other
PUBLIC RECORDS: This olan. and related documents. may be subject to public inspection and copying. (IND 69.02(6)
I. This application forew Bldg Addn to Bldg Alteration Revision to previously reviewed plan ILHR 70 Hist Bldg
2. The Department has processed a Petition for Variance for this project? ED Yes No; Preliminary Review? Yes No
3. Review of the following building components is requested. Plans and calculations are included for each component.
LJ Footing Foundation Building Structural HVAC Other:
4. The following construction classification type is requested and shown on plans. #1 Fire Resist. #2 Fire Resist.
#3 Metal Frame Prot 0#4 Hvy Tmbr 0#5A Msnry Prot 0#5B Msnry ❑#6 Metal Frame 0#7 Wood Frame Prot X#8 Wood Frame
5. If plans do not show compliance with requested construction classification, but are approvable at a lower class, do you wish plan approval at
the lower construction classification? Yes No
6. SOIL BEARING CAPACITY: The Soil Bearing used for is PSF. This value is presumed verified
7. BUILDING SYSTEMS: Please check appropriate boxes Complete sprinkler Partial sprinkler Fire alarm Emergency Power
Complete detection system Partial detection system. For partial systems, show area protected on plans or by letter.
8. MECHANICAL INFORMATION: Total output rating of heating units is: BTUH. Air cond. Full Partial None
Primary fuel source is Gas Oil Electric L.P. Coal Wood Solar Other
COMPONENTS INCLUDED WITH THIS SUBMITTAL 10. FEES See current fee summary or IND 69.09; and back of form.
NOTE: Must be submitted by building designer Building:..Volume. C.F....S th(
Designer Name Reg. No HVAC' Volume C.F....S
METAL S.F.-3 BUILDING Supplier Alteration* Area
Structural: (Separate submission only) S
Designer Name Reg. No Ftg Fdn: (Separate submission only) S
TRUSSES Supplier Revision to previously reviewed plan S
Industrial Exhaust
Designer Name Reg. No
PRECAST Other:
CONCRETE Supplier Priority Review (Total of above fees) S
Permission to Start
Designer Name Reg. No
LAMINATED Inspection Fee 7
WOOD Supplier Tote! J.
OFFICE USE ONLY Date: 71/D 5 D
Designer Name Reg. No ❑Owner
OTHER Fee
(SPECIFY) ';uP 1ef Paid Designer
By: Other
11. DESIGN ANO SUPERVISION (ILHR 50.07 50.10) If this building. following construction of Mis project contains more than 50.000 cubic 1eat to1a1 volume. all applicable boxes below must be
'completed prior to plan review. The project designer is the person who signed and sealed the plans. except for components designed and sealed by other designers. Plena let buildings over
50.000 C.F. will nol be reviewed undl the signature et the supervising preleeslonal(s) Is provided. The 0epartmenl expects. and requires. Mal the proles designer review individual component
submittals for compliance with the general design concept The project designer. and department. will rely on the seal of the component designers for compliance with the codes as they apply to
their designs.
Name of Building Designer (Type or Print) Reg. No. Name of HVAC Designer (Type or Print) Reg. No.
Name of Professional Supervising Building (Type or Print) Reg. No. Address
c•^nature of Professional Supervising Building Date
Name of Professional Supervising HVAC (Type or Print) Reg. No. Address
Signature of Professional Supervising HVAC Date
Se- I l8 (R. 10/861