HomeMy WebLinkAboutS1-23-0306-HVAC
~
OJH<OfH
ON T", WATER
City of Oshkosh
Division of Inspection Services
215 Church Avenue
PO Box 1130
Oshkosh WI 54903-1130
www.cLoshkosh.wLus
March 13, 2006
Michael Leberfing
Badger Metals Inc.
911 South Lynndale Dr,
P.o. Box 1034
Appleton, WI 54912-1034
Friday's Auto Deals
1800 Harrison Street
Oshkosh, WI 54901
Site:
Friday's Auto Deals
1800 Harrison St
Oshkosh WI 54901
For:
Description: HV AC alterations
Object Type: HV AC only
Class of Construction: VB - 960 Sq Ft.; Unsprinklered
Occupancy: B: Business I Office, S: Storage
Plan Number: SI-23-0306
The submittal described above has been reviewed for conformance with applicable Wisconsin Administrative Codes and
Wisconsin Statutes. The submittal has been CONDITIONALLY APPROVED. The owner, as defmed in Chapter
101.01(10), Wisconsin Statutes, is responsible for compliance with all code requirements
Key Hem(s) I Conditions:
IBC 406.6.3 Ventilation. Garages shall be mechanically ventilated in accordance with the International
Mechanical Code. The ventilation systern shall be controlled at the entrance to the garage.
IMC 304.4 Public garages. Appliances located in public garages, service stations, repair garages or other
areas frequented by motor vehicles, shall be installed a minimum of 8 feet (2438 mm) above the floor.
Where motor vehicles exceed 6 feet (1829 mm) in height and are capable of passing UDder an appliance,
appliances shall be installed a minimum of2 feet (610 mm) higher above the floor than the height of the
tallest vehicle. Exception: The requirements of this section shall not apply where the appliances are
protected from motor vehicle impact and installed in accordance with Section 304.3 and NFP A 88B.
IMC 307.1 Liquid combustion by-products of condensing appliances shall be collected and discharged to
an approved plumbing fixture or disposal area.
IMC 401.5 Opening Location Outside air exhaust and intake openings shall be located a minimum of 10
feet (3048 mm) from lot lines or buildings on the same lot. Where openings front on a street or public way,
the distance shall be measured to the centerline of the street or public way.
IMC 401.5.1 Mechanical and gravity outside air intake openings shall be located a minimum of 10 feet
from any hazardous or noxious contaminant such as vents, chimneys, plumbing vents, streets, alleys,
parking lots and loading docks.
lhhriann'2()O6 Comm Plan Review'.s1-23-D306 ¡ 800 II""i"'n Sf].lV AC' only.de"
page 1 of2
IFGC 401/Comm 65.0400 All gas piping and gas piping installations shall comply with NFP A 54,
National Fuel Gas Code.
IFGC 619.2 Support. Suspended-type unit heaters shall be supported by elements that are designed and
constructed to accommodate the weight and dynamic loads. Hangers and brackets shall be of
noncombustible material.
NEC 511.3 (B) (1) For each floor, the entire area up to a level of 18 inches above the floor shall be
considered a Class I Division 2 location. Since no continuous ventilation has been provided to
declassifY this area, all wiring in this location is required to meet the requirements of wiring and
equipment in a Class 1 location. This would prohibit the installation of the electric baseboard heaters
within 18 inches of the floor.
Comm 61.31(4) Revisions to approved plans. All proposed revisions and modifications which involve
rules under this code and which are made to construction documents that have previously been granted
approval by the department or its authorized representative, shall be submitted to the office that granted the
approval. All revisions and modifications to plans shall be approved in writing by the department or its
authorized representative prior to the work involved in the revision or modification being carried out. A
revision or modification to a plan, drawing or specification shall be signed and sealed in accordance with
Comm 61.31(1).
SUBMIT:
. Comm 61.50 (4) Supervision. Prior to the initial occupancy of an alteration the supervising professional
shall file a compliance statement fonn SBD-9720 with this office.
A copy of the approved plans, specifications, and this letter shall be on-site during construction. All permits are required to
be obtained prior to commencement of work.
In granting this approval the City of Oshkosh Inspection Services Department reserves the right to require changes or
additions should conditions arise making them necessary for code compliance. As per state stats 101.12(2), nothing in this
review shall relieve the designer of the responsibility for designing a safe building, structure, or component.
Inquiries concernmg this correspondence may be made to me at the number listed below or the address on this letterhead.
Resp~
~
Building Systems Consultant
(920) 236-5051 Monday-Friday 7:30 A.M. to 8:30A.M and 12:30 A.M to 1:30P.M.
bnoe@ci.oshkosh.wi.us
cc: Property f¡]e
Fee Required $
Fee Received $
Balance Due $
230.00
230.00
0.00
!t..bn<cm'20Ü6 Comm PI,," R,vl,w\SJ-23-0306 :goo II<CTlsol1 Sf ¡WAC only.de"
page 2 of2